-
Hot motor
HI,
Something has been going on for a while now. I have a bondtech extruder and when printing from the right side, the motor heats up to the point where I can melt a strand of filament by keeping it on the motor for a few seconds. The extreme heat melts the filament inside and makes it impossible to push through, leading to air prints. Any solutions? Some sort of mod like a heat sink?
please help
I did not find the right solution from the internet.
References:
http://forum.raise3d.com/viewtopic.php?t=2705
Teaser video production company
Thanks
-
Member Post Likes / Dislikes - 0 Likes, 0 Dislikes
Check Todays Deals on Ebay.co.uk
Check Todays Deals On Amazon.co.uk